CAR NUTS AND GEAR HEADS CHRISTMAS GIFT IDEAS

October 2018 ยท 3 minute read



Hook up the pump to the only vacuum port on your EGR valve. There will be a small hose attached, that you will need to disconnect and install your pump onto the same port. With the engine running at an idle you should be able to pump the vacuum pump to create vacuum on the EGR valve. The diaphragm inside the EGR Valve should raise and cause the car to die. If your car does die then your EGR Valve and it’s ports are fine. If your car stumbles or doesn’t have any change in the way it runs when you’re pulling vacuum then you probably have a bad EGR Valve or a clogged port in your intake.

You can go buy some belt dressing and follow the directions on the package. Belt dressing works wonders for a squealing fan belt and it can keep the squeal away for a long time. You can purchase belt dressing at a auto parts store near me or just about any department store that sells car supplies.

Hold a towel over the glass and tap the glass with the soft end of a screwdriver to break the glass outward onto the tarp. Use needle nose pliers and gloves to remove the larger pieces of broken glass first. Place the glass in a plastic bag for disposal. Use a vacuum hose next to remove smaller pieces and other debris from the opening; vacuuming out the wall underneath the window also to remove dust and dirt.

First, visit an auto salvage tampa and buy a wire brush. Then, disconnect the terminals from your car battery and scrub off the grime and corrosion that has accumulated on the poles. Look at the interior of the terminals and clean them is they’re dirty. Cleaning the battery improves the connection and reduces the chances of losing a charge. Once they’re poles and terminals are clean, reconnect them.

advance auto parts near me Pop your hood and locate the brake fluid reservoir and unscrew the cap or lid on it. If your pads are significantly low, the fluid should appear to be low but do not worry.

Twist the battery terminals by hand. auto parts store near me open now should not move on the posts. If you can move them, loosen the nut and remove the negative terminal first, then the positive. Use a battery terminal cleaner to clean the terminals and posts. Check the cables where they connect to the terminal to see if they are frayed or loose. On some battery terminals, the cable is clamped on. Tighten the clamp bolts if they are loose. For a frayed cable, if the cable is long enough, you can loosen the bolts, cut off the frayed part of the cable, strip just enough insulation off the cable to attach to the terminal, and clamp it down by tightening the bolts. If the cable is not long enough or it is not a clamp type terminal, you will have to replace the frayed cable.